Since installing hub centric wheel spacers not only brings a visual change for vehicle but also gives drivers a more comfortable driving experience, more and more 350z owners buy nissan 350z spacers but most of them are facing installing 350z wheel spacers problem. In fact, as long as you order correct wheel spacers for 350z, the 350z spacers installation is not difficult. Related reading : What Size Wheel Spacer Fits a 2003-2008 Nissan 350z
After receiving 350z 25mm wheel spacers or 20mm wheel spacers from Hexautoparts,you could follow 2003-2008 Nissan 350z wheel spacers installation instructions to complete this DIY project.
Here is the 1-2 hours quick and easy installation.
-Jack up either the front or rear of the 350z and properly support on jack stands.
-Use socket to loosen the lug nuts and remove the tires.
-Clean the studs thoroughly and remove any excessive dirt, oil or grease.
-The back of the 350z wheel spacers sit flush against the 350z's hub.
-Thread the supplied lug nuts to axle studs with tapered end facing towards the spacers.
-Install the nuts by hand only and tighten them in a crisscross pattern.
-Put the wheel back on and install the lug nuts.
-Remove the jack stands and lower the350z then tighten the lug nuts.
After completing these 350z hub centric wheel spacers installation, you can see it comes out a little bit up in and space out the wheels gives it that wide flush look. Anyway, 350z looks better than before.
Note：
-Don't use impact wrench when installing 350z wheel spacers
-Don't use the stock lug nuts but the lug nuts that came with when installing new 350z wheel spacers
